AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Lattice synplify pro mf515 error3/15/2024 ![]() ![]() The same simple test works with my other test board with LCMXO2-1200HC-4TG144C. Windows XP Pro SP3 (fresh install and available updates) no luck - Wine based Windows XP emulation runs (sic) - Windows 10 Pro 64 bit installed from scratch in a virtual machine runs - Windows 10 Pro 32 bit installed from scratch in a virtual machine - runs Looks like there's some kind of problem with 'native' Windows XP support. I've checked the clock from the 50MHz oscillator and it looks fine. The programming does complete successfully with an earlier version of the Lattice Diamond programmer (v3.8) but then a simple test blinky doesn't work, just no output on the pins, they sit a 0V with the current chip, with the previous chip it was more weird where it would allow to output high on one pin but not on the other and would act as if there was no clock input. I had chips ordered from Alibaba and thought the chips had some issue but now I've ordered a couple from Arrow and these give the same error. This is the 3rd chip I'm trying this with with the same result. INFO - Device1 LCMXO2-256HC: FLASH Erase,Program,VerifyĮRROR - function CHECK_SECURITY_PROTECT_KEY INFO - Check configuration setup: Successful. The programmer works fine with LCMX02-1200HC-4TG144C, but with LCMXO2-256HC-4SG32C it gives me the following output: Starting: "pgr_program run" Trying to progamm LCMXO2-256HC-4SG32C with this ebay progammer. ![]()
0 Comments
Read More
Leave a Reply. |